The Graphex System incorporates Neopor, an insulating board made in Germany. Neopor is a graphite composite board made from expanded graphite amalgamated granules. When combined with standard 1.8 batts it has at least 30% better insulation than the Building Code requirement. Insulation Values for the Graphex system with standard 1.8 batts on a 20mm cavity: Graphex StandardThe standard Graphex system comes in 40mm or 60mm Neopor sheets. The sheets are fixed directly to the exterior framing over the surface of a 20mm cavity and are then reinforced with fibreglass mesh that is embedded in PSL Plaster. Once the mesh coat has dried, it is covered in a decorative finishing plaster of the owner’s choice. 
Graphex SolidThe Graphex Solid system comes in a 40mm or 60mm ribbed sheet, with a full meshed solid 12mm crack resistant plastered coat and on a 20mm vented cavity. 
Graphex OverlayTougher thermal performance standards apply to all new houses and buildings. The most difficult houses to insulate are block and masonry houses. PSL have designed a cost effective system to insulate masonry homes which maximizes the benefits of the thermal mass. The insulation properties of the 40mm Graphex overlay will produce an R-value of 1.7. This R-value will exceed the building code changes in all regions in New Zealand. 
System Guarantee Period - 15 Years from date of practical completion. Graphex comes with a Customer Protection Warranty which provides cover for defective workmanship or non-completion of relevant building work in the event of subcontractor insolvency, disappearance or death. Click here for more info on our Free Customer Protection Warranty For technical data sheets or further information visit the PSL website www.plastersystems.co.nz |